Sand & Polish

Sydney Timber Flooring has vast experience in re-sanding and coating timber floor to produce a new floor.
Parquetry, Bamboo, Floorboards, Floating timber floors or prefinished solid timber floors can all be sanded back to bare timber and re-finished at a quarter of the cost of installing a new floor. We use the latest dustless machines with efficient dust bags to control more than 98% of the dust that is created. We recommend covering book shelves and electronic equipment.
Sydney Timber Flooring provides a full service in:

Sand and polish of new timber floors
Sand and polish / restoration of old timber floors
Re-coating of existing floors
Staining of existing or new timber floors
Removal and disposal of old floor coverings
Repair of old or broken boards
Repair of water damaged flooring

Sanding provides a method for smoothing an installed floor, compensating for unevenness of the subfloor. Additionally, sanding is used to renew the appearance of older floors. No beveled edges, as seen in some pre-manufactured prefinished floors, will be evident in a sanded floor. Sanding using successively finer grades of sandpaper is required to ensure even stain penetration when stains are used, as well as to eliminate visible scratches from coarser sandpaper grades used initially.

Sydney Timber Flooring will work with you to determine the best finish for your wooden flooring. Consideration is given to the way your floor is used and amount of traffic to the area. Generally, there are three main types of finishes that are available.

1. Solvent based Polyurethane,
2. Water based Polyurethane and
3. Tung/Modified Oil.

All these finishes are applied in 3 coats, each product has its own distinct advantages. At Sydney Timber Flooring we use and recommend the use of water based polyurethanes and oil based sealers for new floors.

We do not recommend the use of Solvent based polyurethane or other products that may cause edge bonding. As timber flooring continues to move throughout its life due to changes in atmospheric conditions, we advise the use of products that allow the boards to move independently of one and other. Oil based sealers, modified oils and some water based polyurethanes will allow free movement of the boards whereas solvent based polyurethane often bonds the edges of the boards together which may result in 4 or 5 boards being glued tightly together and excessive gaps appearing on either side of these boards.

x character
No job we cant take on board.